Instructions

1. Open the included heat pack and set it to the side, allowing it to activate. The heat pack is designed to maintain the temperature of the Fast Pass between 90-100 degrees.
   
   
2. Unscrew the cap and open the induction seal. This is the foil seal under the lid.
   
   
3. Heating – There are three ways you can heat Fast Pass.
   
   
   1. Microwave – This is the fastest option. Microwave for 5-7 seconds. This should bring your Fast Pass between 90-100 degrees.
      
      
   2. Solar – The Fast Pass solar bottle is designed to heat in direct sunlight. During a hot, sunny day, you can heat Fast Pass in direct sunlight. This should raise the temperature between 90-100 degrees within 30 minutes. Make sure you shake every 5-10 minutes to ensure even heating.
      
      
   3. Heat Pack Only – You can heat Fast Pass with just the heat pack. This typically takes around 45 minutes.
      
      
4. After heating Fast Pass to between 90 and 100 degrees, use the included rubber band to attach the heat pack to your bottle. This will help maintain the urine temperature between 90 and 100 degrees for 5-6 hours.
   
   

IMPORTANT: If your bottle of Fast Pass is warm to the touch but does not show anything on the temp strip, it is likely too hot. The temp strip will only read between 90-100 degrees. Anything over 100 degrees will not register on the strip.

Simply let your Fast Pass cool down so that it shows between 90-100 degrees.